Transactions on Additive Manufacturing Meets Medicine
Vol. 4 No. S1 (2022): Trans. AMMM Supplement
https://doi.org/10.18416/AMMM.2022.2209682

Material Properties, Structural Designs, and Printing Technologies, ID 682

Digital-Light-Processing technologies to manufacture biocompatible bone scaffolds

Main Article Content

Sven Malte Krümpelmann (Department of Orthopedics and Trauma Surgery, University Medical Center, Kiel), Julie Kühl (Experimental Trauma Surgery, Department of Orthopedics and Trauma Surgery, University Medical Center, Kiel, Germany), Leah Picek (Experimental Trauma Surgery, Department of Orthopedics and Trauma Surgery, University Medical Center, Kiel, Germany), Andreas Seekamp (Experimental Trauma Surgery, Department of Orthopedics and Trauma Surgery, University Medical Center, Kiel, Germany), Sabine Fuchs (Experimental Trauma Surgery, Department of Orthopedics and Trauma Surgery, University Medical Center, Kiel, Germany)

Copyright (c) 2022 Infinite Science Publishing

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

In today’s trauma surgery the treatment of critical sized bone defects can cause different problems, such as stability issues and impaired healing processes. The defects often have an irregular shape and result from inflammation, tumor resection or trauma.


Additive manufacturing technologies can support the filling and healing process of such critical sized bone defects. With that in mind the aim of our project is, to build a biocompatible scaffold with a spongiosa like structure using Digital-Light-Processing (DLP) technology. This printing approach has a lot of advantages compared to other printing technologies. DLP with the printer used (Lumen X, Cellink) enables to print up to a resolution of 50 micrometer allowing to build scaffolds with high and biomimetic details. Further, this technology is useful to integrate cells directly into the printing process, because of the low cytotoxicity of the applied wavelength (405nm) in combination with biocompatible BioInk´s.


In our study we established a biocompatible BioInk composed of Gelatine-Methacryloyl (GelMa) a photoinitiator and a photoabsorber. We were able to show the increased biocompatibility compared to commercially available alternatives by analyzing the cellular proliferation and differentiation of mesenchymal stem cells (MSC´s) and MG63 (osteosarcoma cell line) encapsulated into the BioInk.


The scaffolds printed by the established BioInk had more than four times higher DNA content after 7 days compared to the commercial GelMa BioInk alternative, indicating cellular proliferation. Confocal laser scanning imaging of the different scaffolds underlined these results. Cells in the commercial alternative BioInk stayed round in their shape while cells in self-made BioInk showed an elongated morphology after staining with Hoechst and Phalloidin TRITC and survived up to over 2 weeks.


In further studies we will analyze how bioactive substances integrated into the BioInk support cell proliferation and differentiation towards an osteogenic phenotype.

Article Details

How to Cite

Krümpelmann, S. M., Kühl, J., Picek, L., Seekamp, A. ., & Fuchs, S. (2022). Digital-Light-Processing technologies to manufacture biocompatible bone scaffolds. Transactions on Additive Manufacturing Meets Medicine, 4(S1), 682. https://doi.org/10.18416/AMMM.2022.2209682