Transactions on Additive Manufacturing Meets Medicine
Vol. 3 No. 1 (2021): Trans. AMMM
https://doi.org/10.18416/AMMM.2021.2109608

Printed Anatomy for Planning, Training, and Phantoms for Quality Assurance, ID 608

Creation of a 3D printed human head phantom

Main Article Content

Solveig Thrun (Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering IMTE, Lübeck, Germany), David Pedrosa (Department of Neurology, University Hospital of Giessen and Marburg, Marburg, Germany), Maximilian Schulze (Department of Neuroradiology, University Hospital of Giessen and Marburg, Marburg, Germany), Thorsten M. Buzug (Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany and Institute of Medical Engineering, University of Lübeck, Lübeck, Germany), Maik Stille (Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany and Institute of Medical Engineering, University of Lübeck, Lübeck, Germany)

Copyright (c) 2021 Transactions on Additive Manufacturing Meets Medicine

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

Deep brain stimulation (DBS) is a neurological intervention to treat neurological diseases such as Parkinson’s disease. The postoperative position determination of the electrode is critical to determine if the surgery was successful. This study aimed to develop a human head phantom by using additive manufacturing (AM). With these phantom new findings in postoperative position determination on computed tomography images can be gained. Necessary to that end, the head phantom should be as anatomically correct as possible. Furthermore, the brain and the bones should be represented with realistic CT values on computed tomography (CT) images. The first measurements showed that the CT values of the 3D printed skull correspond to the CT values of the human skull and the CT values of the phantom’s brain are equivalent to values slightly above these of the human brain.

Article Details

How to Cite

Thrun, S., Pedrosa, D. ., Schulze, M. ., Buzug, T. M., & Stille, M. (2021). Creation of a 3D printed human head phantom. Transactions on Additive Manufacturing Meets Medicine, 3(1), 608. https://doi.org/10.18416/AMMM.2021.2109608 (Original work published September 8, 2021)

Most read articles by the same author(s)

<< < 1 2